Case, end plates (to be remade), perf board, storage capacitor, in/out cable, and mounting hardware.
Schematic
Parts List
Layout
Reference:
Coil Polarity: http://mgaguru.com/mgtech/ignition/ig104.htm
StudeM15A-20 Rescue Project I bought this old Stude truck off ebay in 2010 and have been working on it since. I don't plan to restore it but just get it in useful condition and enjoy it's utility.
Tuesday, December 15, 2015
6 Volt Positive Ground CDI
Here is the start of the project. I'll be using a Tiger SST CDI case and make new end plates to mount the transformer and perf board. Ordered all electronic components except the storage capacitor which I already have. Plan to mount the power transistors on an aluminum plate that will slide into the case like the original.
Layout
CDI with Points
Standard Ignition without CDI
Pertronix Ignition
Tracing new end plates
New end plates cut out and drilled
Fitting heat sink
Heat sink with inverter transistors, SCR, and bridge rectifier mounted and pre-wired
Checking heat sink fit
Circuit board mounting
Circuit board assembled
Layout
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment